Thursday, September 20, 2018

1997, 1998 Ford Mustang Keyless Remote Programming Instructions

This keyless remote programming instruction works on this 4b remote with part # F5DZ-15K601-B, and FCC id GQ43VT4T

Replacement Remote F5DZ-15K601-B, GQ43VT4T
Replacement Remote

NOTE: The program connector is located in the trunk, behind the rear left hand side
access panel, taped to the wiring harness between the left tail light and the rear left
wheel well. It is a plastic connector that is NOT plugged into anything.

1. Put the ignition switch in “RUN” or “ACC” and momentarily jumper the two program connector terminals with a suitable jumper wire. The system will respond by locking and unlocking all of the doors.
2. Press any button on the transmitter. All doors will lock and then unlock to verify transmitter signal acceptance.
3. Repeat step 2 for each transmitter (including your old ones) in order to program the remote keyless entry module to accept up to four transmitter signals.
4. Turn the ignition switch to “OFF”. All of the doors will then lock and unlock.

No comments:

Post a Comment

Share