Saturday, September 29, 2018

1996 Chevrolet Tahoe Keyless Remote Programming Instructions

This keyless remote programming instructions work for (2060) 3B remote with part # 15692636, 15955515, 15955516, 25609144, 25555951, 15692336, 10239647, 25559364, 25609144, 15657587, 15955702, 15725423, new 15731442, FCC id ABO0103T, ABO0104T on the back of it.

Replacement Remote 15692636, 15955515, 15955516, 25609144, 25555951, 15692336, 10239647, 25559364, 25609144, 15657587, 15955702, 15725423, 15731442, ABO0103T, ABO0104T
Replacement Remote
Please Note: When your system is programming a new remote it will automatically disable/delete the existing ones so make sure to reprogram them as well if you wish to use multiple remotes for your car.

1. Insert keys in ignition and leave it OFF position.
2. Locate the Data Line Connector (DLC) underneath the driver's side dasboard. Use the figures below as a map for your DLC (they usually aren't numbered) based on how your DLC is positioned. The view in the picture below is looking straight into the cavities of the DLC. Notice how the DLC is tapered on both ends: We will be working on the wider row of cavities (1 through 8 in the figure below).
3. To put the system in programming mode check if there are metal contact pins in terminals 8 and 4 and connect the Data Line Connector (DLC) terminal 8 to terminal 4 using a jumper wire. Door locks will cycle.
4. Press and hold both LOCK and UNLOCK buttons on the remote until the door locks cycle (Lock and Unlock). Then release the buttons on the remote.
5. To program another remote just go back to step 4.
6. Remove the jumper wire from the DLC (disconnect terminals 8 and 4).
7. Test the remotes.


No comments:

Post a Comment

Share