Thursday, September 20, 2018

1995, 1996, 1997, 1998 Ford Windstar Keyless Remote Programming Instructions

This keyless remote programming instruction works on this 3b remote with FCC id # GQ43VT4T

Replacement Remote GQ43VT4T
Replacement Remote
Warning: Your programming connector could be located behind or under the glove compartment
(attached to the relay mounting panel or taped to the wire assembly) and can be accessed by dropping the glove compartment. It can be white or light gray plastic connector with two terminals that is not plugged into anything. Colors of these wire can be grey/yellow or white/yellow.

1. Put the ignition to ON or ACC and momentarily jump the two program connector terminals with a suitable jumper wire. The system will respond by locking and then unlocking all doors or chirping the horn. After that, remove the jumper wire.
2. Press any button on the remote. Then door locks will cycle or horn will chirp to indicate the remote
has been programmed.
3. Press any button on each additional remotes (including your old ones) allowing a pause for the door locks to cycle after each remote. The keyless entry system will allow up to four remotes to be programmed.
4. Turn the ignition to OFF position. All doors will lock then unlock or the horn will chirp.

No comments:

Post a Comment

Share