Tuesday, September 25, 2018

1995, 1996, 1997 Lexus LS400 Keyless Remote Programming Instructions

This keyless remote programming instruction works on this remote with part # 89742-50510 and FCC id HYQWDT-C

Replacement Remote 89742-50510, HYQWDT-C
Replacement Remote
1. Before programming make sure driver door is unlocked and OPEN. All other doors are closed.
2. Put the key in the ignition (don’t turn it) and pull it out.
3. Do these steps within 40 seconds:
a. Switch on the driver’s door using the power lock/unlock and do 5 lock/unlock cycles starting with lock. A lock/unlock cycle consists of pressing the power lock switch, followed by pressing the power unlock switch on the driver’s door panel. Use an even pace and try to go relatively fast.
b. Close then open the driver’s door.
4. Do the steps below within 40 seconds:
a. Perform 5 lock/unlock cycles again with the switch on the driver’s door starting with lock.
b. Put the key in the ignition. Turn the ignition to ON (don't start the engine) then back to OFF two times.
c. Take the key out from the ignition. Within 3 seconds, the power door locks should cycle (lock then unlock) automatically which means you're now in programming mode. If not, start from the top.
5. Again, do these steps within 40 seconds:
a. Press any button on the remote. Within 3 seconds the door locks should cycle once. If door locks did not cycle then repeat this step because your remote has not been accepted.
b. Close then open the door once.
c. Press any button on the same remote. Within 3 seconds the door locks should cycle which means your remote has been successfully programmed. If not, or cycled twice then your remote hasn't been programmed.
d. To program another remote just go back to steps 5a-c.
6. Once you're done, clode the driver's door.

No comments:

Post a Comment

Share