Thursday, September 20, 2018

1994, 1995, 1996, 1997, 1998 Ford Mustang Keyless Remote Programming Instructions

This keyless remote programming instruction works on this 4b remote with part # F5DZ-15K601-B, and FCC id GQ43VT4T

Replacement Remote F5DZ-15K601-B, GQ43VT4T
Replacement Remote
Warning: Your programming connector could be located behind or under the glove compartment
(attached to the relay mounting panel or taped to the wire assembly) and can be accessed by
dropping the glove compartment. It can be white or light gray plastic connector with two
terminals that is not plugged into anything. Colors of these wire can be grey/yellow or white/yellow.

1. Put the ignition to ON or ACC and jump the two program connector terminals with a suitable jumper wire. The system will respond by cycling the door locks or chirping the horn. After that, remove the jumper wire.
2. Press any button on the remote. Then door locks will cycle or horn will chirp to indicate the remote
has been programmed.
3. Press any button on your other remotes to program them and wait for the door locks to cycle for
each remote. The keyless entry system will allow up to four remotes to be programmed.
4. Turn the ignition to OFF position. All doors will lock then unlock or the horn will chirp.

 


No comments:

Post a Comment

Share