Thursday, September 20, 2018

1994, 1995, 1996, 1997 Ford Bronco Keyless Remote Programming Instructions

This keyless remote programming instruction works on this 3b remote with FCC id GQ43VT4T

Replacement Remote GQ43VT4T
Replacement Remote
Note: The programming connector is taped to the wire assembly leading to the keyless entry receiver module (approximately 6 inches from the receiver,) which is located on the driver’s side of the lower instrument panel to the right of the steering column, just above the driver’s right foot. It’s a white or light gray plastic connector with two terminals that is not plugged into anything.

1. Put the ignition to RUN or ACC and momentarily jump the two program connector terminals with a suitable jumper wire. The system will respond by locking and then unlocking all doors.
2. Press any button on the first remote. All doors will lock and unlock to verify programming of that remote.

3. Press any button on each additional remotes (including your old ones) allowing a pause for the door locks to cycle after each remote. The keyless entry system will allow up to four remotes to be programmed.
4. Turn the ignition to OFF. All doors will lock then unlock.

No comments:

Post a Comment

Share