Thursday, September 20, 2018

1993, 1994, 1995, 1996, 1997 Mercury Cougar Keyless Remote Programming Instructions

This keyless remote programming instruction works on this 4b remote with FCC id # GQ43VT4T

Replacement Remote GQ43VT4T
Replacement Remote
ATTENTION: The connector is located in the trunk, behind the rear left hand side panel, taped to the wiring harness between the left tail light and the rear left wheel well. It's a plastic connector that is NOT plugged into anything.

1. Twist the key in the ignition to “RUN” or “ACC” then jumper the two program connector
terminals using a jumper wire. The system will respond by cycling the door locks (lock/unlock).
2. Press any button on the remote. The door locks will cycle if the remote is paired with the system.
3. Do step 2 for additional remotes (including the old ones) in order to program the remote keyless entry module to accept up to 4 remote signals.
4. Turn the ignition switch to “OFF” and the door locks will cycle.

No comments:

Post a Comment

Share