This keyless remote programming instructions work for L,U,P remote with part # 89742-20200 BAN 89742-0C020 BAN 89742-42120 BBX and FCC id HYQ12BAN, HYQ12BBX.
Start with the following conditions:|
a. Key is out of the ignition
b. Driver door is OPEN (all other doors are closed).
c. Driver door is unlocked.
2. Insert the key into the ignition (don’t turn it) and pull it out.
3. Perform these steps within 40 seconds:
a. Using the power lock/unlock switch on the driver’s door, perform 5 lock/unlock cycles starting with lock. A lock/unlock cycle consists of pressing the power lock switch, followed by pressing the power unlock switch on the driver’s door panel. Use an even pace and try to go relatively fast.
b. Close then open the driver’s door.
4. Do these within 40 seconds:
a. Lock and unlock 5 times using the power lock switch again and switch on the Driver's door starting with lock.
b. Put the key in the ignition.
c. Turn the key in the ignition to ON position then turn it back off. (Make sure the engine did not start)
d. Remove the key from the ignition.
5. Within 3 seconds the power door locks will lock and unlock. That means you're now in programming mode. If not, then go back to step 1.
6. Perform these steps within 40 seconds:
a. Press the LOCK and UNLOCK buttons on the transmitter simultaneously for 1 second and release.
b. Immediately after letting go of the lock and unlock buttons, press the UNLOCK button by itself and release. Within 3 seconds, the door locks should cycle (lock then unlock) once indicating successful programming. If the door locks cycle twice (two lock and unlock cycles), this means your remote has not been accepted. Repeat steps 6a and 6b until the door locks cycle only once.
c. Repeat steps 6a and 6b for each remote including old ones.
7. Close the driver’s door.