Share

Friday, August 3, 2018

2006, 2007, 2008, 2009, 2010 TOYOTA RAV-4 Keyless Remote Programming Instructions

This keyless remote programming instructions work for rav-4 rhk 06-10 remote with part # 89070-42540 89070-42660 FCC id HYQ12BBY.

1. Start with the following conditions:
a. Key is out of the ignition
b. Driver door is open (all other doors are closed)
c. Driver door is unlocked (other doors don’t matter).
2. Perform the next two steps within 5 seconds:
a. Insert the key into the ignition (don’t turn it) and pull it out.
b. Insert the key into the ignition (don’t turn it) and pull it out.
3. Perform these steps within 40 seconds:
a. Close then open the driver’s door.
b. Close then open the driver’s door.
c. Insert the key into the ignition (don’t turn it) and pull it out. 
4. Now, do all these within 40 seconds:
a. Close then open the door twice.
b. Put the key in the ignition.
c. Close the door the again.
d. Turn the key to ON position in the ignition then turn it back OFF. (Again, don't start the engine)
e. Take the key off the ignition. 
5. The door locks will cycle (lock and unlock) which means you're in programming mode. If not, then you need to start all over again.
6. Perform these steps within 40 seconds:
a. Press the lock and unlock buttons on the transmitter simultaneously for 1 second.
b. Immediately after releasing the lock and unlock buttons, press the unlock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle (lock then unlock) once indicating successful programming. If the door locks cycle twice, repeat steps 6a and 6b for this remote as it has not been accepted.
7. Open driver’s door.

No comments:

Post a Comment