Share

Friday, August 3, 2018

2004 LEXUS RX330 Keyless Remote Programming Instructions

This keyless remote programming instructions work for RHK grey guts L,U,P triangle on unlock remote with part # 89070-48020 FCC id NI4TMTX-1.

1. Before programming your remote make sure:
a. There are no keys in the ignition.
b. Your door (Driver's door) is open and unlocked others are closed.
2. Now, do this twice within 5 seconds:
a. Put your key in and out the ignition. (Don't start the engine)
3. Do these within 40 seconds:
a. Close then open the door twice.
b. Put your key in the ignition and pull it out once. 
4. Now, do all these within 40 seconds:
a. Close then open the door twice.
b. Close the door again.
c. Put your key in the ignition.
d. Turn the key to ON position in the ignition then turn it back OFF. (Again, don't start the engine)
e. Take the key off the ignition. 
5. The door locks will cycle (lock and unlock) which means you're in programming
mode. If not, then you need to start all over again.
6. Perform these steps within 40 seconds:
a. Press the lock and unlock buttons on the transmitter simultaneously for 1 second and release.
b. Immediately after releasing the lock and unlock buttons, press the unlock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle (lock then unlock) once indicating successful programming. If the door locks cycle twice, repeat steps 6a and 6b for this remote as it has not been accepted.
c. Within 40 seconds, repeat steps 6a and 6b for each additional transmitter.
7. Open driver’s door.

No comments:

Post a Comment