Share

Friday, August 3, 2018

2003 TOYOTA TUNDRA Keyless Remote Programming Instructions

This keyless remote programming instructions work for L, U, (P on back) remote with part # 08191-00922 FCC id BAB237131-056.

1. Start with the following conditions:
a. Key is out of the ignition
b. Driver door is open (all other doors are closed)
c. Driver door is unlocked (other doors don’t matter).
2. Perform the next two steps within 5 seconds:
a. Insert the key into the ignition (don’t turn it) and pull it out.
b. Insert the key into the ignition (don’t turn it) and pull it out.
3. Perform these steps within 40 seconds:
a. Close then open the driver’s door.
b. Close then open the driver’s door.
c. Insert the key into the ignition (don’t turn it) and pull it out. 
4. Perform these steps within 40 seconds:
a. Close then open the driver’s door.
b. Close then open the driver’s door.
c. Insert the key into the ignition.
d. Close the driver’s door.
e. Turn the ignition to ON (as far as you can go without cranking your engine) then back to OFF.
f. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should cycle (lock then unlock) automatically indicating successful entry into programming mode. Return to Step 1 if the locks do not cycle at this point.
6. Within 40 seconds do these steps:
a. Press the lock and unlock buttons on your remote at the same time then release.
b. After doing step (a) press and hold the unlock button on your remote for 2 seconds. The door locks should lock then unlock within 3 seconds indicating that the programming is successful. If the door locks cycle twicem go back to step (a and b) since the system hasn't recognized the remote yet.
7. Open the driver's door.

No comments:

Post a Comment