Share

Wednesday, August 1, 2018

1999, 2000 HONDA ODYSSEY Keyless Remote Programming Instructions

This keyless remote programming instructions work for 5B PSD remote with part # 72147-S0X-A01 FCC id E4EG8DN and part # G8D-440H-A on the back of it.

CONSIDER: Once you're on programming mode your car's system will reset and you may need to reprogram your other remotes that are already paired to it. Separate your key and remote from your keychain.

1. You should use your key in your right and remote in your left hand. Then insert your key to the ignition.
2. Now, do these steps 3 times in 15 seconds:
a. Turn the ignition to ON position and you'll notice panel lights will turn on. But you don't need to start the engine.
b. Press the UNLOCK button on your remote.
c. Turn the ignition to LOCK and leave the key.
3. Within 5 seconds turn the ignition to ON.
4. Press the UNLOCK button on the same remote and release. The power door locks will cycle to confirm the system is in programming mode.
5. Within 10 seconds press the UNLOCK button on the same remote. The door will lock and unlock to indicate that the system accepted your remote.
6. Repeat step 5 to program other remotes.
7. Turn your key back to LOCK and remove it from the ignition. This indicates that you're done programming your remotes.

No comments:

Post a Comment