Thursday, July 26, 2018

2001, 2002, 2003 ACURA CL Keyless Remote Programming Instructions


This keyless remote programming instructions work for 4B Omron remote with part numbers 72147-SZ3-A9272147-S0K-A132147-S0K-A1272147-S0K-A23 FCC id E4EG8D-444H-A and part # G8D-444H-A on the back of it.



IMPORTANT: Entering the programming mode cancels all learned remote codes, so no previously
programmed remotes will work. You must program all remotes, including existing ones now.
Separate your ignition key from remotes on keychain.

1. Start with your key in your right hand and any remote in your left hand. Keep all additional
remotes easily accessible to your left hand. Insert the key into the ignition.

2. Perform these steps within 5 seconds:

a. Turn the ignition to the ON position (where the instrument panel lights are turned
on without starting the engine.)
b. Press the UNLOCK button on the remote and release.
c. Turn the ignition back to LOCK (the position where the key is inserted) and leave
the key in the ignition.
d. Turn the ignition to the ON position (where the instrument panel lights are turned
on without starting the engine.)
e. Press the UNLOCK button on the remote and release.
f. Turn the ignition back to LOCK (the position where the key is inserted) and leave
the key in the ignition.
g. Turn the ignition to the ON position (where the instrument panel lights are turned
on without starting the engine.)
h. Press the UNLOCK button on the remote and release.
i. Turn the ignition back to LOCK (the position where the key is inserted) and leave
the key in the ignition.
3. Within 5 seconds turn the ignition to ON.

4. Press the UNLOCK button on the same remote and release. The power door locks will
cycle to confirm the system is in programming mode.
5. Within 10 seconds press the UNLOCK button on your remote and the car door should lock
and unlock. Now your remote and the system are married.

6. If you have another remote to program, just repeat the step 5.

7. Once you're done programming, turn the key back to LOCK position and remove it.

No comments:

Post a Comment

Share