Tuesday, July 31, 2018

2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009 HONDA S2000 Keyless Remote Programming Instructions

This keyless remote programming instructions work for L,U,T,P OPTION remote with part # 39950-S01-A01, 72147-S2A-A01, 08E61-S01-100, 08E61-S10-100, 72147-S10-A51, 08E61-S70-101, 72147-S10-A52 cheap FCC id A269ZUA101, E4EG8DJ and part # G8D-452H-A on the back of it.



IMPORTANT: Entering the programming mode cancels all learned remote codes, so no previously
programmed remotes will work. You must program all remotes, including existing ones now.
Separate your ignition key from remotes on keychain.

1. Start with your key in your right hand and any remote in your left hand. Keep all additional
remotes easily accessible to your left hand. Insert the key into the ignition.

2. Perform these steps within 5 seconds:

a. Turn the ignition to the ON position (where the instrument panel lights are turned
on without starting the engine.)
b. Press the UNLOCK button on the remote and release.
c. Turn the ignition back to LOCK (the position where the key is inserted) and leave
the key in the ignition.
d. Turn the ignition to the ON position (where the instrument panel lights are turned
on without starting the engine.)
e. Press the UNLOCK button on the remote and release.
f. Turn the ignition back to LOCK (the position where the key is inserted) and leave
the key in the ignition.
g. Turn the ignition to the ON position (where the instrument panel lights are turned
on without starting the engine.)
h. Press the UNLOCK button on the remote and release.
i. Turn the ignition back to LOCK (the position where the key is inserted) and leave
the key in the ignition.
3. Within 5 seconds turn the ignition ON.

4. Press the UNLOCK button on your remote. The door will lock and unlock to verify the
system is in programming mode.
5. Within 10 seconds press the UNLOCK button on the same remote again and release. The
door locks will cycle to confirm that the system accepted this remote.

6. Repeat step 5 for second or third remotes.

7. Turn the key back to LOCK and remove from ignition to exit programming mode.

No comments:

Post a Comment

Share